miniature switches 44 litho in u.s.a gg ordering table washable toggle switches designed to be wave soldered along with other printed circuit board components and withstand associated cleaning processes. how to order your design ( bold face type indicates items normally in distributor stock) following the table from left to right, the designer is able to specify the options wanted. the options are described and illustrated on the following pages. washabletoggle switch selection guide poles toggle and lever lever bushing terminal contact series throw circuit options finish options type material + * momentary contact 2 pole only. subtract .030 from lever length when using this bushing. available on s and m lever options only. available only with l3 and l4 lever options only. ++++++ no. spdt dpdt code 1 2 pos. "c" on off on on none on on none on* on* off on* on off on* on on on on on on* on* on on* type .940 bat. .740 bat. .650 bat. long mod cap short mod cap .510 bat. .300 bat. code 21 23 26 27 31 32 33 35 type .250 smooth .280 smooth .350 threaded .350 smooth code 1 3 4 5 6 code d1 d9 y y9 type right angle pc vertical pc .150 spacing pc terminals pc & support .750 wire wrap .964 wire wrap .425 wire wrap 1.062 wire wrap solder lug quick connect code a av2 c v30 w w1 w3 w4 z z3 type gold/brass gold/silver coin/silver subtract .100 from lever length when using these bushings. refer to page 59 for construction detail, wiring and electrical diagrams. not available on a, av2, v30 terminal options. same as b, g and q respectively except terminals brass with tin nickel alloy over nickel plate. consult plant for availability. to determine a part number select the options desired and fill in the boxes in the selection guides illustrated below. finish bright chrome black black nylon red nylon white nylon code l0 l1 l2 l3 l4 s m code b g q k l m specifications: contact ratings letter codes g and q 6 amp at 125 vac, 3 amp @ 250 vac ( u.l. recognized, csa certified ) or 6 amp at 28 vdc resistive. letter codes b and g C 0.5 volt amp (va) maximum @ 28 v maximum (ac or dc). life under load 60,000 make-and-break cycles resistive load only. initial contact resistance 10 milliohms maximum 3 vdc, 100 ma for both silver and gold plated contacts. insulation resistance 1,000 megohms, min. dielectric strength 1,000 volts rms at sea level. operating temperature -30 degrees c to 85 degrees c. materials: base & bushing thermoplastic high temperature (ul 94v-o). lever (toggle) brass, chrome plated. support brackets brass or steel tin plated. switching contacts and rockers letter code b gold/nickel/brass letter code g gold/nickel/silver letter code q coin silver center terminal letter codes b and g gold flash/nickel/brass letter code q silver plated brass. hardware see pages 55-57. code wt series poles and throw circuits lever options and finishes bushing options terminal options contact material type toggle examples: wt123m1d9ab = spdt toggle switch with an on-none-on circuit, .270" long lever (see note 2 above) with a bright chrome finish, .280" smooth bushing right angle p.c. terminals with gold/brass contacts. wt232s1d1v30g = dpdt toggle switch with an on-on-on circuit, .510" long lever with a bright chrome finish, .250" smooth bushing, p.c. terminals with support bracket and gold/silver contacts. keyway
miniature switches litho in u.s.a gg 45 one pole washable toggle switches base dimensions and lever options s std. bat. (.510") l0 long (.940") l1 long (.740") l2 long (.650") l4 plastic (.671") toggle lever options approximate base dimensions two pole m short (.300") l3 plastic (.940")
miniature switches 46 litho in u.s.a gg termination options c printed circuit w wire-wrap w1 wire-wrap w3 wire-wrap w4 wire-wrap z standard z3 quick connect mating receptacle from amp special ind., p.o. box 984, paoli, pa. 19301 amp p/n single piece 61454 series, strip from 60900 note: wire-wrap is a registered trademark of the gardner-denver company. a one pole p.c. mounting p.c. mounting washable toggle switches d1 standard (.250") smooth bushing options d9 (.280") smooth y (.350") threaded y9 (.350") smooth termination & mounting options a two pole
miniature switches litho in u.s.a gg 47 washable toggle switches termination & mounting options contd. av2 one pole p.c. mounting av2 two pole p.c. mounting v30 one pole p.c. mounting v30 two pole p.c. mounting
|
